Fitting & Installation

Stair Runner Guide: What to Know Before You Buy

• Hollie

A stair runner is a strip of carpet that runs down the middle of your stairs, leaving some of the tread showing at each side. To choose one, measure your stairs, pick a hard-wearing material, then choose a style and colour. Fit it over underlay and gripper on every step, with rods or clips if you like.

Key takeaways

  • We suggest 5–10 cm of tread showing each side, depending on your preference.
  • Measure tread plus riser for every step, then add your landings.
  • Wool is soft and resilient; polypropylene is tough and easy to clean.
  • Secure every step with underlay and gripper. Rods and clips are mainly decorative.
  • Order samples to check colour and feel at home before you buy.

What is a stair runner?

A stair runner is a long strip of carpet that covers the centre of a staircase, leaving a border of the stairs showing on each side. It's held in place on every step with underlay and gripper, and often finished with stair rods or clips.

Runners protect the treads from wear, soften footsteps and add grip compared with bare wood or paint. They also let you show off the staircase itself, and they're easier to change than a fitted carpet. Runrug's stair runners are made to measure: cut to the length you need, with bound edges, so they're ready to lay. Many people carry the same design across the landing with a matching hall runner for a joined-up look.

How do you choose a stair runner?

Measure first, then narrow down material, style and fixings. These six steps take you from tape measure to order.

You'll need

  • A tape measure
  • A notepad, or your phone
  • A rough count of your steps and landings
  • A few samples of the runners you like
  1. Measure the stair width. Measure across a tread, from one side to the other. If your stairs vary, use the narrowest point.
  2. Choose your runner width. Decide how much of each tread you'd like to show. We suggest 5–10 cm each side, depending on your preference.
  3. Measure the length. Measure one tread and one riser, multiply by the number of steps, then add any landings. Our measuring guide covers winders and landings.
  4. Pick a material. Wool for softness and resilience, polypropylene for a tough, easy-clean runner, or a flat weave for a low, tailored look.
  5. Choose a style and colour. Plain, striped, bordered or patterned. Order samples and look at them on the stairs in daylight.
  6. Choose your fixings. Plan for underlay and gripper on every step, and add stair rods or clips if you like the look.

💡 DIY tip: Measure every step on an older staircase. Treads and risers can vary by a centimetre or two, and a few small differences add up over a full flight.

How wide should a stair runner be?

That's down to your taste, but we suggest leaving 5–10 cm of tread showing on each side. A wider border shows off more of the staircase, while a narrower one gives a fuller, more carpeted look.

Stair width Suggested runner width
75 cm 57–60 cm
80 cm 60–70 cm
90 cm 70–80 cm
100 cm 80–90 cm
110 cm 90–100 cm
130–140 cm 120 cm

Runrug runners come in widths from 57 cm to 120 cm. For example, a 90 cm stair suits a 70–80 cm runner. If your staircase opens onto a hall, keep the stair border a little tighter than the hall runner's, which usually shows more floor.

How much stair runner do you need?

Measure one tread (the part you step on) and one riser (the upright part), add them together, then multiply by the number of steps. Add the depth of any landings you want to cover.

If your treads have a rounded front edge (a nosing), measure over it rather than straight across. Winders and curved stairs need each step measured separately. Our step-by-step measuring guide walks you through all of this.

Because Runrug runners are cut to the length you order and bound at the edges, it pays to measure carefully and check your figures before you buy.

Which material is best for a stair runner?

Stairs take more wear than almost any other floor, so choose a material that's hard-wearing first and soft second.

Material Feel Wear Cleaning Best for
Wool Soft and warm Naturally resilient, springs back Gentle care: cool water, no bleach Comfort and a classic look
Polypropylene Firmer Hard-wearing Resists water-based stains, easy to clean Busy family homes and pets
Flat weave Low and smooth Tight weave, little to snag Vacuums easily Modern, tailored stairs
Wool blend Soft with extra strength Durable As wool A balance of both

Runrug sells both 100% wool and polypropylene runners. For a deeper comparison, read our guide to the best materials for a stair runner.

Which stair runner style suits your home?

Start with the rest of your hallway: the flooring, the wall colour and the banister. Then choose a style that either blends in or makes the stairs the focal point.

  • Plain: calm and timeless, and easy to match with patterned walls or tiles.
  • Striped: draws the eye up the stairs and suits period and modern homes alike.
  • Bordered: a contrasting edge frames each step for a tailored finish.
  • Traditional: rich patterns hide everyday wear on busy stairs.
  • Modern: geometric and abstract designs for a contemporary look.

Need more inspiration? See our stair runner ideas and trends, or our guide to choosing a stair runner colour.

What's the best stair runner for wooden stairs?

A runner on wooden stairs shows off the wood at each side, so the border matters more. We suggest the full 5–10 cm each side to frame the treads, depending on how much wood you want to see.

Choose a runner with a firm, tight construction, so the edges sit neatly against the wood. Fit it over underlay and gripper on every step, which stops it sliding on a smooth surface. Stair rods in brass, chrome or black look especially good against painted or stained wood.

If your stairs are newly sanded or varnished, let the finish cure fully before you lay the runner.

Do you need underlay, rods or clips?

You need underlay and gripper. Rods and clips are optional and mostly decorative.

  • Underlay sits under the runner on each tread. It makes the runner softer underfoot, helps reduce noise and protects the runner from wear against the step edge.
  • Gripper holds the runner in place on every step. Cut it 2 cm shorter than the runner width, so it sits about 1 cm in from each edge and stays hidden.
  • Stair rods or clips sit where the tread meets the riser. They add a finishing touch and help keep the runner in line, but they don't replace gripper.

Our stair runner underlay and gripper pack gives you both in one. For help with the finishing touch, read stair rods or stair clips: which should you choose?

Should you fit it yourself or hire a fitter?

Either works. Runrug supplies runners made to measure and bound, ready to lay, but we don't fit them, so it's your choice.

Many people fit a straight staircase themselves in an afternoon with basic tools. Our guide on how to fit a stair runner takes you through it step by step.

For winders, curved or open-sided stairs, or if you'd rather not do it yourself, hire your own independent carpet fitter. Ask two or three for a quote, tell them the number of steps and any winders or landings, and check whether underlay, gripper and rod fitting are included.

How do you look after a stair runner?

Vacuum it weekly and deal with spills straight away. Stairs collect grit from shoes, and grit is what wears a runner fastest.

  • Vacuum each tread and the front edge of every step once a week with a handheld vacuum or a stair tool. On wool, use suction only, or turn off the beater bar if your vacuum allows it.
  • Blot spills straight away with kitchen roll, working from the edge inwards, and never rub.
  • Check the gripper and rods every few months, and tighten anything that's worked loose.

Our guide on how to clean a carpet runner covers deeper cleaning and stain removal.

Where should you buy a stair runner?

You can buy stair runners from carpet shops, department stores and online specialists. Whichever you choose, look for a runner cut to your length, in the width you want, with properly bound edges. Check what's included too: underlay, gripper and rods are often sold separately, so add them to your list before you compare.

Buying made-to-measure online gives you more choice of widths, materials and designs than most showrooms can hold. You can order samples first to check colour and feel at home. Runrug was founded in 2011, and the family behind it has a heritage in flooring going back to 1945.

💡 Runrug tip: Order three or four £2.50 samples and lay them on a stair in morning and evening light. Colours shift a lot between daylight and lamplight.

Shop this guide

FAQs

How wide should a stair runner be?

It's your choice, but we suggest leaving 5–10 cm of tread showing on each side. That means a 90 cm wide stair suits a runner of about 70–80 cm. A wider border shows off more of the staircase, while a narrower one looks fuller. Runrug runners come in widths from 57 cm to 120 cm.

What is the best material for a stair runner?

Wool and polypropylene are both good choices. Wool is soft, warm and naturally resilient, so it springs back well under foot traffic. Polypropylene is firmer, hard-wearing and easy to clean, which suits busy homes and pets. A flat weave in either material gives a low, tailored look and is easy to vacuum.

Do stair runners need underlay?

Yes, we recommend underlay on every step. It makes the runner softer and quieter underfoot and protects it from wearing against the edge of each step. Use it with gripper, cut 2 cm shorter than the runner width, so the runner stays firmly in place.

Can you fit a stair runner yourself?

Yes. A straight staircase is a manageable DIY job with basic tools, underlay, gripper and a staple gun or tacks. Take your time over the first step, because it sets the line for the rest. For winders or curved stairs, you may prefer to hire your own independent fitter.

Where is the best place to buy a stair runner?

Look for a supplier that cuts runners to your length, offers a range of widths and binds the edges properly. Buying made-to-measure online usually gives you the widest choice of materials and designs. Order samples first, so you can check the colour and feel in your own home before you buy.

About the author: Hollie, Runrug Product Team

Hollie is part of the Runrug Product Team. She writes about the practical side of runners: measuring, choosing widths and materials, stair rods and underlay, and step-by-step DIY guides to laying a runner yourself.

Last reviewed 7 October 2026 by Hollie · First published 6 January 2025